Wrangler years to avoid—and the years we refuse to over-rank

The official record identifies a condition that deserves candidate-specific inspection and record verification.

“Frame Weld Deficiencies In a letter received on October 24, 2018, a citizen petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a safety defect investigation into frame weld deficiencies on model year (MY) 2018 'JL' Jeep Wrangler vehicles. The petitioner described a broad list of frame weld deficiencies, including porous welds, excessive slag, lack of weld penetration, over penetration of welds, overweld or weld drip, and weld splash. The weld defects are allegedly located at a variety of locations on the frame assembly.On November 16, 2018, the Office of Defects Investigation (ODI) opened a Defect Petition (DP18-004) to evaluate whether to grant or deny the petition. On March 8, 2019, ODI sent an Information Request letter to Fiat Chrysler Automobiles (FCA) requesting information on frame weld related issues on all MY 2018-2019 Jeep Wrangler 'JL' vehicles. Due to a previous steering related recall that was caused by a misaligned weld on the front track bar (NHTSA Recall No. 18V-675), ODI opted to include a request for additional information concerning reports of steering shimmy or wobble, loose steering, and steering lockup in the March request letter. ODI has performed a preliminary analysis on the information obtained from FCA. Based on ODI's review of the applicable materials, NHTSA has decided to grant the petition. While reviewing the applicable materials obtained from the manufacturer, ODI identified various reports and references to frame welded component detachments that were outside of the scope of NHTSA Recall No. 18V-675. Additionally, the information that FCA provided did not adequately address whether frame weld quality deficiencies compromise the structural integrity of vehicles, and therefore may pose an unreasonable risk to motor vehicle safety. Finally, ODI needs to further evaluate the alleged steering-related defects reported through MY 2019 and the alleged defects' relation to weld quality.The petition was granted on September 16, 2019. Preliminary Evaluation PE19-012 has been opened to further assess the scope, frequency, and potential safety-related consequences of alleged weld quality deficiencies and steering related concerns on the MY 2018-2019 'JL' Jeep Wrangler vehicles.The ODI reports cited above can be viewed on NHTSA.gov under the following reference numbers:11234967, 11222390, 11219370, 11217080, 1204905, 11179954, 11171786, 11161243, 11155523, 11153044, 11143617, 11142722, 11142426, 11141336, 11141035, 11140637, 11140344, 11140262, 11140085, 11140057, 11139880, 11139866, 11139557, 11139467, 11139436, 11138974, 11138758, 11138757, 11132030, 11129738, 11129667, 11124312, 11120232, 11119676, 11119650, 11119454, 11119450, 11115658, 11115137, 11113029, 11112515, 11110583, 11109903, 11093172, 11088501, 11076098”

The official record identifies a condition that deserves candidate-specific inspection and record verification.

“Frame Weld Deficiencies In a letter received on October 24, 2018, a citizen petitioned the National Highway Traffic Safety Administration (NHTSA) to initiate a safety defect investigation into frame weld deficiencies on model year (MY) 2018 'JL' Jeep Wrangler vehicles. The petitioner described a broad list of frame weld deficiencies, including porous welds, excessive slag, lack of weld penetration, over penetration of welds, overweld or weld drip, and weld splash. The weld defects are allegedly located at a variety of locations on the frame assembly.On November 16, 2018, the Office of Defects Investigation (ODI) opened a Defect Petition (DP18-004) to evaluate whether to grant or deny the petition. On March 8, 2019, ODI sent an Information Request letter to Fiat Chrysler Automobiles (FCA) requesting information on frame weld related issues on all MY 2018-2019 Jeep Wrangler 'JL' vehicles. Due to a previous steering related recall that was caused by a misaligned weld on the front track bar (NHTSA Recall No. 18V-675), ODI opted to include a request for additional information concerning reports of steering shimmy or wobble, loose steering, and steering lockup in the March request letter. ODI has performed a preliminary analysis on the information obtained from FCA. Based on ODI's review of the applicable materials, NHTSA has decided to grant the petition. While reviewing the applicable materials obtained from the manufacturer, ODI identified various reports and references to frame welded component detachments that were outside of the scope of NHTSA Recall No. 18V-675. Additionally, the information that FCA provided did not adequately address whether frame weld quality deficiencies compromise the structural integrity of vehicles, and therefore may pose an unreasonable risk to motor vehicle safety. Finally, ODI needs to further evaluate the alleged steering-related defects reported through MY 2019 and the alleged defects' relation to weld quality.The petition was granted on September 16, 2019. Preliminary Evaluation PE19-012 has been opened to further assess the scope, frequency, and potential safety-related consequences of alleged weld quality deficiencies and steering related concerns on the MY 2018-2019 'JL' Jeep Wrangler vehicles.The ODI reports cited above can be viewed on NHTSA.gov under the following reference numbers:11234967, 11222390, 11219370, 11217080, 1204905, 11179954, 11171786, 11161243, 11155523, 11153044, 11143617, 11142722, 11142426, 11141336, 11141035, 11140637, 11140344, 11140262, 11140085, 11140057, 11139880, 11139866, 11139557, 11139467, 11139436, 11138974, 11138758, 11138757, 11132030, 11129738, 11129667, 11124312, 11120232, 11119676, 11119650, 11119454, 11119450, 11115658, 11115137, 11113029, 11112515, 11110583, 11109903, 11093172, 11088501, 11076098”

The official record describes a potential crash, fire, injury, or loss-of-control consequence.

“Instrument Panel Cluster (IPC) Failure The Office of Defects Investigations (ODI) is opening a Preliminary Evaluation on 2020 Model Year Jeep Gladiators and Wranglers involving a malfunctioning Instrument Panel Clusters (IPC) resulting in the loss of important vehicle metrics and other status information.  ODI has received 89 Vehicle Owner Questionnaires (VOQs) alleging a complete or partial loss of the IPC display while driving.  The subject vehicles' IPC display includes the speedometer, fuel gauge, engine temperature, turn signal indicators, warning light, and other gauges that are normally illuminated while the vehicle is in operation.  Loss of the fuel gauge while driving may lead to an inability to determine the fuel level and result in a loss of motive power, and the loss of other safety-related information may impede a driver’s ability to take action to prevent a safety risk.  Furthermore, an IPC that is suddenly not visible to the driver may divert the driver’s attention from the driving task, potentially causing a vehicle crash. ODI is opening this Preliminary Evaluation to evaluate the scope, severity and frequency of the alleged IPC malfunctions and to assess potential safety-related consequences. To review the ODI reports cited in the Opening Resume ODI Report Identification Number document, go to NHTSA.gov”

The official record describes a potential fatal consequence.

“Underhood fires The Office of Defects Investigation (ODI) has received 9 Vehicle Owner's Questionnaire (VOQ) reports, 1 Death and Injury report, and multiple field reports alleging incidents of engine compartment fires in model year (MY) 2021-2023 Jeep Wrangler and Gladiator vehicles. The majority of the reports describe a fire occurring while the ignition in the vehicle was in an ‘OFF’ state with a suspected origin at the passenger front side of the engine compartment. An ignition ‘OFF’ vehicle fire can result in an increased risk of occupant injury, injury to persons outside the vehicle, and property damage, with little to no warning. ODI has contacted the vehicle manufacturer, Fiat Chrysler Automobiles (FCA), and learned of several thermal events originating at the power steering pump electrical connector in recent model year Jeep Wrangler and Gladiator vehicles. The location of the pump connector is located at the passenger front side of the engine compartment, coinciding with the majority of fire reports known to ODI. ODI is opening this Preliminary Evaluation (PE) to assess the cause, scope, and frequency of the alleged defect. To review the ODI reports cited in the Opening Resume ODI Report Identification Numbers document, go to NHTSA.gov.”

The official record identifies a condition that deserves candidate-specific inspection and record verification.

“Pedestrian alert sounds NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.”