2017 Toyota Tacoma inspection checklist

The records describe a problem worth checking before purchase.

“TL* THE CONTACT OWNS A 2017 TOYOTA TACOMA. THE CONTACT STATED THAT WHILE DRIVING IN HEAVY SNOW AT 50 MPH, THEY CRASHED INTO SEVERAL ELK IN THE ROAD. THE AIR BAG FAILED TO DEPLOY. THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC. THE DRIVER AND PASSENGER OCCUPANT SUSTAINED INJURIES TO THE NECK, CHEEK AND BACK HOWEVER MEDICAL ATTENTION WAS NOT PROVIDED. A POLICE REPORT WAS FILED. THE LOCAL DEALER WAS NOT CONTACTED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED. THE FAILURE MILEAGE WAS 87,000. THE VIN WAS NOT AVAILABLE”

The records describe a problem worth checking before purchase.

“Truck has 116k miles, started losing power and acceleration diminished. CEL and Trac Off light came on. Pulled over twice after experiencing same issue. Took to mechanic and diagnostic code P0301 (cylinder 1 misfire). Replaced 6 spark plugs to be safe, and replaced broken coil in cylinder 1. Drove less than a mile and CEL came back on. Brought to dealership this time and they found a leak in the head gasket and noticed warping in cylinder 1, along with code P0301 still present. They reported back to me stating it needed a machinist to resurface the the cylinder head, that the repair is mechanical. Even outside of warranty this fix should not be costing $13,000. The truck has been properly maintained for the past 9 years, all oil services and replacing any wear and tear items. Mechanical (warping) is manufacturing issues.”

The records describe a problem worth checking before purchase.

“Vehicle stalled on highway bridge. Took to mechanic shop. They put the diagnostic code machine on and the code indicated fuel pump failure. Toyota does have a recall notice for the year, make, and model of my vehicle. But not showing on my VIN.”

The records describe a possible crash, fire, injury, or loss of control.

“I PULLED UP TO PARK THE TRUCK. AFTER PUT IN PARK THE 2017 TOYOTA TACOMA LUNGED FORWARD. THIS CAUSED THE VEHICLE TO HIT A BRICK WALL. THERE WAS ALMOST $5950.00 IN DAMAGE TO THE TRUCK AND THE AIRBAGS DID NOT GO OFF. I WATCHED MYSELF CRASH INTO THE WALL AND COULD NOT STOP THE TRUCK.”

The records describe a problem worth checking before purchase.

“Clear coat and paint began to oxidize and fade after 4 years of ownership even when maintaining with wax”

The records describe a possible crash, fire, injury, or loss of control.

“Electrical overstress The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect.  During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW.  The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications.  The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU.  In this recall, FCA discussed an EOS condition that resulted in a failure of the subject DS84 ASIC, which caused air bag non-deployment.  FCA noted that the defect condition had only been observed in vehicles equipped with sensor harnessing routed across the front of the vehicle.  Other FCA vehicles that also used the subject ACU, but were not equipped with cross-car harnessing, had not experienced EOS failures, despite similar time in service. During the course of this investigation, ODI sent two separate Information Request (IR) letters to six vehicle manufactures (including FCA, Hyundai, Honda, Kia, Mitsubishi, and Toyota) and one IR letter to ZF-TRW.  These IR letters resulted in ODI receiving comprehensive data from these manufacturers and suppliers. Studies of this data found that the DS84 ASIC does not have sufficient protection against negative electrical transients or electrical overstress (“EOS”) that can be generated in certain severe crashes.  An electrical transient occurs when the electrical power supplied to a circuit changes momentarily over a short duration of time.   In these severe crash cases, the crash sensors and other powered wiring can be damaged and short circuited so as to create a negative electrical transient of sufficient intensity and duration (that are outside the vehicle manufacturer's specification) to damage the ASIC before the restraint device deployment signal is received by the SRS ECU.  This damaged signal can lead to incomplete or nondeployment of the air bags and/or pretensioners.  Airbag non-deployment and/or lack of pretensioner operation can increase the risk or severity of injury in a crash.A total of 8 fatalities and 14 injuries were associated with known EOS events. The common element in all investigated manufacturers vehicles is the SRS ECU containing a DS84 ASIC manufactured by ZF-TRW.  The risk associated with the ASIC is equally shared among all OEMS involved in the investigation.  The actual real-world risk can be mitigated by other factors which were assessed by ODI during this investigation. The first mitigating factor involves protections built into the ACU design which protect the DS84 ASIC from damage.  There are multiple strategies and levels of protection employed by different OEMs that provide effective EOS mitigation.  The two most common strategies at the ACU level are circuit protection diodes on the remote senor signal lines, and current limiting resistors that protect critical components. The second mitigating factor is found at the vehicle level and involves the location and routing of the wires leading from the crash sensors to the SRS ECU.  If the wires are well protected in a crash and are not routed with other power wires carrying large currents, the risk for an EOS event is significantly reduced or eliminated. These design specific factors combine to produce a spectrum of risk for the vehicles equipped with ACUs using the DS84 ASIC.  Given the many of years of field exposure, it is possible to divide the subject population into two groups; vehicles which have experienced EOS events, and vehicles which have not experienced EOS field events. Four of the six OEMs involved in this investigation have experienced EOS field events on at least one of their models equipped with a DS84 ASIC.  All vehicle models (including the Toyota models identified in the Failure Report Summary of the opening resume for this investigation) with field events have been recalled.  In an abundance of caution, ODI kept this investigation open five years to monitor field performance and did not identify any field events on vehicles not included in existing safety recalls. Given the spectrum of risk identified in this investigation and that all vehicles with a demonstrated unreasonable risk have been recalled, ODI is closing this investigation. ODI is closing this investigation with the following manufacturer safety recalls: 16V-668, 18E-043, 18V-137, 18V-363, and 20V-024.  With the recall actions taken by the subject vehicle and equipment manufacturers, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exists on other model or model year vehicles outside of the recall scopes. The agency reserves the right to take further action if warranted by the circumstances.”

The records describe a possible crash, fire, injury, or loss of control.

“Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016-2017 Tacoma vehicles. Oil may leak from the area where the rear differential carrier is assembled to rear axle housing. If the vehicle is operated with an insufficient amount of oil in the rear differential, the differential may seize and cause a loss of control, increasing the risk of a crash. Toyota will notify owners, and dealers will inspect the rear differential for oil leakage. Based on the inspection, dealers will either tightening the fastening nuts or replace the fastening nuts and gasket. If the rear differential components are damaged, the rear differential carrier assembly will be replaced. The repairs will be performed free of charge. The recall June 19, 2017. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is H0G.”

The records describe a possible crash, fire, injury, or loss of control.

“Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016-2017 Tacoma vehicles equipped with a six-cylinder engine. The affected vehicles have a crank position sensor that may malfunction, potentially resulting in an engine stall. An engine stall may increase the risk of a crash. Toyota will notify owners, and dealers will replace the crank position sensor with an improved design, free of charge. The recall began July 26, 2017. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is H0H.”

The records describe a possible crash, fire, injury, or loss of control.

“Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2017-2018 Toyota 4Runner and Tundra, 2018 Toyota Highlander, RAV4 and Lexus GX460 and 2017 Toyota Sienna and Tacoma vehicles. These vehicles may have incorrect load carrying capacity modification labels. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims." An incorrect load information label can result in the operator overloading the vehicle and increasing the risk of a crash. Toyota will notify owners and provide them with corrected labels, free of charge. The recall began on January 23, 2018. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's numbers for this recall are H0Z for Toyota vehicles, and HLF for Lexus vehicles.”

The records describe a possible crash, fire, injury, or loss of control.

“Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018 Toyota Camry and Highlander vehicles, 2017 Toyota Sienna and Tacoma vehicles and 2017 Lexus RX350 vehicles. During the manufacturing process, the oil galley in the rotor for the brake booster vacuum pump assembly may have been improperly machined possibly resulting in a sudden loss of brake assist. A sudden loss of braking assist can increase the risk of a crash. Toyota will notify owners, and dealers will replace the brake booster vacuum pump, free of charge. The recall began on May 9, 2018. Owners may contact Toyota customer service at 1-888-270-9371, or Lexus customer service at 1-800-255-3987. Toyota's numbers for this recall are J0K/JLD.”

The records describe a possible crash, fire, injury, or loss of control.

“Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2019 4Runner, 2019-2020 Avalon, 2019 Corolla Hatchback, 2017-2019 Highlander, 2018-2020 Camry, 2020 Corolla, 2018-2019 Land Cruiser, 2017-2020 Tacoma, 2019-2020 RAV4, 2019-2020 Sequoia, 2017-2020 Sienna, 2019-2020 Tundra, 2018-2020 Lexus ES350, 2017 Lexus GS200t, 2017-2019 Lexus GS350, 2019 Lexus GS300, 2018-2020 Lexus LC500h, 2019-2020 Lexus LS500, 2018-2019 Lexus GX460, 2017 Lexus IS200t, 2019 Lexus IS300, 2019 Lexus IS350, 2018-2020 Lexus LC500, 2018 Lexus LS500, 2019 Lexus LS500h, 2018-2019 Lexus LX570, 2017 Lexus RC200t, 2019 Lexus RC300, RC350, 2017 and 2019-2020 Lexus RX350, 2018-2020 RX350L, 2019 Lexus UX200, 2018-2019 Lexus NX300 vehicles. The low-pressure fuel pump inside the fuel tank may fail. If the fuel pump fails, the engine can stall while driving, increasing the risk of a crash. Toyota will notify owners, and dealers will replace the fuel pump assembly with an improved one, free of charge. Owners of specific models were notified that remedy parts were available starting January 21, 2021. Owners of other models will be notified as remedy parts become available. Remedy parts should be available for all affected vehicles by late March 2021. Owners may contact Toyota customer service at 1-888-270-9371 or Lexus customer service at 1-800-255-3987. Note: This recall is an expansion of recall 20V-012. Toyota's number for this recall is 20TA02. Lexus' number for this recall is 20LA01.”

The records describe a problem worth checking before purchase.

“Toyota Safety Recall and Service Campaign - Technician Certification Requirements”

The records describe a problem worth checking before purchase.

“DL: On December 20, 2022, a settlement of claims for certain low pressure fuel pumps was approved by the federal court. The settlement includes Toyota?s agreement to provide a Customer Support Program for certain 2014-2020 model year (MY) vehicles originally equipped with low pressure fuel pumps repaired under Safety Recall 20TA02, Safety Recall 21TA03, Safety Recall 21TA05 or Special Service Campaign 21TC03. The purpose of this Customer Support Program letter is to help clarify how to administer this coverage in accordance with the settlement.”

The records describe a problem worth checking before purchase.

“Toyota has received some reports of paint peeling along the exterior door window frames and front inner fenders under the hood on certain Tacoma vehicles with 040 Super White paint color. Although the vehicle paint is covered by Toyota’s New Vehicle Limited Warranty for three years, or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to the condition described above.”

The records describe a problem worth checking before purchase.

“Customer Support Program 23TE08 Paint Repair Process”

The records describe a problem worth checking before purchase.

“In our continuing efforts to ensure the best in customer satisfaction, Toyota is announcing a Customer Support Program to provide coverage for paint peeling on door frames and front inner fenders on certain 2016-2022 model year Tacoma vehicles. Toyota has received some reports of paint peeling along the exterior door window frames and front inner fenders under the hood on certain Tacoma vehicles with 040 Super White paint color. Although the vehicle paint is covered by Toyota’s New Vehicle Limited Warranty for three years, or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to the condition described above.”

The records describe a problem worth checking before purchase.

“Toyota has received some reports of paint peeling along the exterior door window frames, front inner fenders as can been seen with the hood open, and on the A-pillars on certain Tacoma vehicles with 040 Super White paint color. Although the vehicle paint is covered by Toyota’s New Vehicle Limited Warranty for three years, or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to the conditions described above.”