Engine owner reports: Ford Fusion years in the records

The records describe a possible crash, fire, injury, or loss of control.

“While driving we noticed the engine light came on so we took it to our local mechanic. He said we were leaking coolant and it was too extensive fro him to fix so he suggested we put coolant in every few days. We researched the problem and found that these cars had a recall for this exact issue yet our VIN does not show it. We went to Ford Dealership and they confirmed we need a new engine as they connected the IDS. This vehicle was built at the Hermosillo plant, has the same 1.5L EcoBoost engine, and has experienced the exact coolant intrusion failure that Ford recalled or extended coverage for on other vehicles. I am asking Fotrd to reconsider my case because my vehicle has the identical defect despite my VIN not being included. My kids purchased this car for my wife and I in October 2025. I also included a VIN Report based on my VIN Number and if scroll to the bottom of that report maybe page 23 you will see the Recall.”

The records describe a possible crash, fire, injury, or loss of control.

“The vehicle experienced engine failure due to coolant intrusion into the cylinders on the engine. I've experienced engine misfires, rough running, check engine light, and I'm worried I'm going to see an eventual engine failure requiring engine replacement. The BIGGEST issue is I've had total loss of power in my engine while on a public road more than once, before the check engine light ever came on. Its terrifying. It is dangerous. And Ford is aware it is dangerous. Ford issued Customer Satisfaction Program 21N12 for certain affected vehicles due to this exact issue, but my vehicle is past the warranty so it's SOL. The failure appears to be caused by a defect in the engine design allowing coolant to enter the combustion chamber. This is clearly a widespread defect as Ford had to create their limited warranty for it. This is something that needs to be recalled for all affected vehicles experiencing coolant intrusion and engine failure because it is not safe to be on the road.”

The records describe a possible crash, fire, injury, or loss of control.

“My 2019 Ford Fusion 2.0L EcoBoost (89,000 miles) experienced a sudden, severe engine malfunction due to a known manufacturing defect. The vehicle exhibited severe engine shuddering and a harsh cold-start misfire upon ignition. A diagnostic scan revealed trouble codes P0316 (Misfire on Startup), P0302 (Cylinder 2 Misfire), and P0304 (Cylinder 4 Misfire). A mechanic verified that these codes are the result of internal coolant intrusion into the engine cylinders, exactly as documented in Ford Technical Service Bulletin TSB 19-2346. The structural design flaw in the engine block allows engine coolant to breach the cylinder head gasket area and pool inside the combustion chambers. This presents a critical safety hazard: the vehicle is at risk of sudden engine stalling while driving on public roads, a complete loss of motive power in traffic, and potential engine hydro-lock, which can cause catastrophic mechanical failure or an engine compartment fire. Ford is refusing to address this safety defect outside of warranty, leaving a hazardous vehicle on the road.”

The records describe a possible crash, fire, injury, or loss of control.

“My 2019 Ford Fusion has been diagnosed with the prominent EcoBoost Coolant Intrusion defect requiring a newer 2020+ redesigned engine replacement. Ford is refusing to replace it or provide any discounts even though it's clearly a engineering defect. The vehicle has just 38,500 miles in 7 years of ownership. It has been regularly well maintained & not driven hard. This is inexcusable that Ford is not standing behind their product that has a plethora of well documented failures on these particular flawed design engines, namely the 2.0L EcoBoost that came in this vehicle.”

The records describe a possible crash, fire, injury, or loss of control.

“Misfire due to cracked cylinder wall letting coolant leak into the cylinder in the 2.0L turbo”